| General Description |
Glas-Lok® GLS is a functionalized polyethylene copolymer-based thermoplastic powder coating designed specifically for glass coating applications that require UV-stabilization. |
| Application Data |
| Surface preparation |
Properly preparing (cleaning) glass surfaces before powder coating is essential for quality finish. This includes cleaning, rinsing, drying and insuring that the substrate surface is free and clear of any contaminates.C-SP6) 2-3 mil anchor profile using clean, sharp edged blast media.
|
NOTE: Properly preparing parts before powder coating is essential for a quality finish. This includes cleaning, rinsing, drying and insuring that the substrate surface is free and clear of any contaminates. |
| Fluidized Bed |
For fluidized bed dipping, preheat parts to 400° F (adjust according to part thickness). Dip parts in fluidized bed of Glas-Lok® GLS for 4 - 6 seconds. Carefully blow off the excess powder. For improved surface finish (if necessary), parts may be post-baked for a short period of time.
|
| Electrostatic Deposition |
For electrostatic deposition, preheat parts to 400° F. Deposit Glas-Lok® GLS 8-12 mils thick. For improved surface finish (if necessary), parts may be post-baked for a short period of time. |
| For complete application details email: techsupport@innotekllc.com |
| NO CURE TIME! |
Thermoplastic powder coatings need only be heated enough to flow out the coating, nothing more. Overheating may cause degradation or embrittlement of the coating. Coating may be put into service when cooled.
|
 |
